Installation preparation of drive shaft on rear axle differential
Task
For use in flow assembly, the handling device is initially synchronized with the line speed via a friction wheel drive. For precise positioning, the system is then indexed via two pins on the workpiece carrier (WC). Subsequently, the adaptation system moves pneumatically into the defined fastening position to reliably fasten the drive shaft to the rear axle differential using an open-end wrench.
Special feature: Open-end wrench, friction wheel drive
Torque: 120 Nm
Payload: 220 kg
handy-lift
Equipment
Equipment
1
Crane rail
2
handy-lift 500 (2x)
3
Pneumatic weight compensation
4
Position query
5
Friction wheel drive
6
Pneumatic equipment
7
Adaptation system
Adaptation system
Equipment
Equipment
1
HMI
2
Switch housing
3
Centering pin with protective sleeve
4
Counter holder tongue
5
Oscillating joint
Adaptation system
Equipment
Equipment
1
EC-spindle
2
Pneumatic cylinder for indexing
3
Angle head
4
Open-end wrench
Further System solutions
Axle assembly
Battery assembly
Gearbox assembly
Motor assembly
Installation preparation
